Compression Control Level Adjustment
This function can compress the dynamic range of music, so
that low sounds which are covered over by road noise can be
raised.
1
Press the DSP button. "DSP CTRL" is displayed once the DSP
control mode is entered.
The DSP indicator blinks during the DSP control mode.
2
Each time you press the COMP button, the compression level
switches as follows;
➨ "Comp Off" ➨ "Comp STEP 1" (Compression level is lower) ➨
"Comp STEP 2" ➨ "Comp STEP 3" (Compression level is higher)
➨
NOTE
The default setting is "Off".
3
Press the DSP button to end the DSP control mode.
Position Setting
This function can set the DSP effects for various listening
positions.
1
Press the DSP button. "DSP CTRL" is displayed once the DSP
control mode is entered.
The DSP indicator blinks during the DSP control mode.
2
Press the POSI button.
The position currently set appears in the display.
3
Each time you press the POSI button, the position switches as
follows;
➨ "ALL" ➨ "Front-Right" ➨ "Front-Left" ➨ "Front" ➨ "Rear" ➨
NOTE
• Be sure to set the balance and fader control to center position.
If their settings are not set to center position, the Position
Setting effect will not be obtained properly.
• The default setting is "ALL".
4
Press the DSP button to end the DSP control mode.
Room Size Setting
This function can set the DSP effects for various room sizes.
1
Press the DSP button. "DSP CTRL" is displayed once the DSP
control mode is entered.
The DSP indicator blinks during the DSP control mode.
2
Press the R.SIZE button.
The position currently set appears in the display.
3
Each time you press the 4 or ¢ button, the room size
switches as follows;
"Room Large" (For large vans or RVs, etc.) j "Room
Medium"(For sedans, etc.) j "Room Small" (For compact cars,
etc.)
NOTE
• This adjustment cannot be made when the Position Setting is
set to "ALL".
• The default setting is "Medium".
4
Press the DSP button to end the DSP control mode.
— 25 —