Kenwood DPX-6020 Instruction Manual page 44

Troubleshooting Guide
External Disc Control Mode
PROBLEM
The disc control mode cannot
be selected.
The specified disc does not
play, but another one plays
instead.
The sound skips.
The display shows that the
changer is being played, but no
sound can be heard.
The specified track will not
play.
If the following situations, consult your nearest service center:
• Even though the disc changer is connected, the Disc Changer Mode is not on, with "AUX Mode" showing in the display during the Changer
Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87, KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, "AUX
Mode" is displayed when switching modes.
The following messages are displayed when certain problems are occurring in your system. Take the recommended
actions.
EJECT No disc magazine has been loaded in the changer. The disc magazine is not completely loaded.
]
Load the disc magazine properly.
No Disc No disc has been loaded in the disc magazine.
]
Load a disc into the disc magazine.
POSSIBLE CAUSE
No wire has been connected to the disc changer input
terminal on the unit.
The specified CD is quite dirty.
The CD is upside-down.
The disc is loaded in a different slot from that specified.
The disc is severely scratched.
Something is touching the disc changer.
The CD is scratched or dirty.
The computer chip in the unit is not functioning normally.
Random play or magazine random play has been selected.
Connect the wire to the disc changer input terminal on the
unit.
Clean the CD.
Load the CD with the labeled side up.
Eject the disc magazine and check the number for the
specified disc.
Try another disc instead.
Remove whatever is touching it.
If skipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
Press the reset button on the unit (see p. 3).
Turn off random play or magazine random play (see p. 20).
— 44 —
SOLUTION