Kenwood DPX-6020 Instruction Manual page 43

PROBLEM
The memory is erased when
the ignition is turned off.
A CD ejects as soon as it is
loaded.
The sound skips on a CD.
A track will not play.
The DSP effects are
imperceptible.
POSSIBLE CAUSE
The battery wire has not been connected to the proper
terminal.
The ignition and battery wire are incorrectly connected.
The CD is upside-down.
The CD is quite dirty.
The CD is scratched or dirty.
Random play has been selected.
You are using a two-speaker system.
The front and rear output are reversed.
The + and - of speakers are reversed.
The fader or balance settings are set all the way to one
side.
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
Load the CD with the labeled side up.
Clean the CD, referring to the section on "Cleaning CDs" (see
p. 5).
Clean the CD, referring to the section on "Cleaning CDs" (see
p. 5).
Turn off random play (see p. 20).
Use a front/rear four-speaker system.
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
Connect the wire correctly, referring to the section on
"Connecting Wires to Terminals".
Reset the fader or balance settings (see p. 7).
— 43 —
SOLUTION