JRC JHS-180 Instruction Manual page 70

Note: IEC61162-2 interfaces comply with the following specifications.
- Output drive capacity: Differential driver output voltage is 2.0V or more (RL=100 ohms), Driver
output current 50mA
- Load on the line of inputs: 100 ohms. 1 IEC61162-1 output can drive 1 IEC61162-2 input.
- Electrical isolation of input circuits: Input circuits are electrically isolated from internal circuit with
opto-isolator.
8.2.4 Supported interface sentences
Indication
1.
SENSOR1
SENSOR2
SENSOR3
SENSOR4
SENSOR5
2.
NSK
3.
AUX1
AUX2
4.
LONGRANGE
5.
DIFF
6.
MAINTE
7. NMEA2000
(Optional)
(*1) Rate of Turn includes errors caused by calculation in the range of +/- 5.6 degree/minute.
8.3 POWER SUPPLY UNIT (NBD-577A)
(1) Input voltage
(2) Output voltage
8-2
Sentence format Supported sentence formatters
IEC61162-1/2
Longitude/Latitude
Position Accuracy
Time of Position
Datum Reference
RAIM Indicator
Speed Over Ground
(SOG)
Course Over Ground
(COG)
Heading
Rate of Turn (*1)
IEC61162-1 Input: VHW
IEC61162-2 Input: ABM, ACA, ACK, AIR, BBM, LRI, LRF, VSD,
IEC61993-2 SSD
Output: ABK, ACA, ALR, DSC, DSI, LRF, LR1, LR2,
LR3, TXT, VDO, VDM
IEC61993-2 Input: LRI, LRF
Output: LRF, LR1, LR2, LR3
ITU-R M.823-2 Input: RTCM SC-104 Ver.2.0 Type 1, 2, 7, 9
Output: RTCM SC-104 Ver. 2.0 Type: depends on
received message
Prepared for future use
IEC61162-3 Prepared for future use
:100 or 220 Vac ±10% 50/60Hz Single phase
:24Vdc (Back up power supply)
:24Vdc
Input data Recommend
GNS
GLL
DTM
GBS
VBW
RMC
HDT
ROT
Optional
GGA
RMC
VTG
OSD
RMC
VTG
OSD
OSD