(2) Check and Set the Channel Management
The inputted Channel Management detail has to be registered to the transponder for channel
management operation.
Pressing the "[Check]" select key checks whether or not the inputted detail can be set to the
transponder, and display "OK" or "NG" as the result.
When the check result was "OK", then select key function "[Set]" is appears on the "[List] "
position.
(Checked Channel Management detail : "OK")
CH MANAGEMENT UTC11:43
BRG : RANGE NAME/MMSI
270°: 0.18NM JRC MARU1
35°: 0.29NM JRC MARU2
22°: 0.92NM JRC MARU1
1.CH A:2087 WIDE TX/RX
2.CH B:2088 NARROW RX
3.TX POWER :HIGH
4.ZONE SIZE:5nm
5.AREA N 35°33.3870' CHECK>
(NE) E139°54.5780'OK
6.AREA N 35°33.3870'
(SW) E139°54.5780' SET>
(Checked Channel Management detail : "NG")
CH MANAGEMENT UTC11:43
BRG : RANGE NAME/MMSI
270°: 0.18NM JRC MARU1
35°: 0.29NM JRC MARU2
22°: 0.92NM JRC MARU1
1.CH A:2087 WIDE TX/RX
2.CH B:2088 NARROW RX
3.TX POWER :HIGH
4.ZONE SIZE:5nm
5.AREA N 35°33.3870' CHECK>
(NE) E139°54.5780'NG
6.AREA N 35°33.3870'
(SW) E139°54.5780' SET>
NG:AREA CONRNER ER NG
5-30
○
○
Pressing this select key checks whether or
not the inputted detail can be registered to the
○
transponder.
○
Pressing this select key registers the inputted
channel management detail to the transponder.
○
○
Pressing this select key checks whether or
not the inputted detail can be registered to the
○
transponder.
Pressing this select key registers the inputted
○
channel management detail to the transponder.
Reason about check result "NG"
Check result "OK"