Troubleshooting - Sharp IG-ETC1A Operation Manual

TROUBLESHOOTING

Before calling for service, please review the TROUBLESHOOTING chart below.
The problem may not be unit malfunctions.
Problem
[ For Main unit ]
The Plasmacluster Ion Generator
does not work.
Unit Replacing Light
is À ashing (red).
Flashing
(red)
Filter Clean Light is
lighting (orange).
Lighting
(orange)
Is this product equipped with OFF
timer and ON timer functions?
The discharged air has odor.
A discontinuous noise is heard.
A clicking or ticking sound
comes from the unit.
The air À ow decreases.
• Is a AC Adapter inserted properly?
Please insert AC Adapter correctly.
• It takes approx. 2 seconds for power distribution after the
plug is inserted in the outlet.
• It is over the usage period of main unit. Replace with new
UNIT
Plasmacluster Ion Generating Unit. (See E-17)
• If the replacement period of the unit is passed, the Unit
Replacing Light (red) flashes rapidly and the operation is
stopped. (See E-17)
• Clean the ¿ lter. (See E-9)
FILTER
• Press the Filter Reset Button for at least 3 seconds.
CLEAN
(See E-9)
RESET
(Press 3sec.)
• If you press the Timer Button (main unit / remote control)
during the operation, "OFF Timer" is set.
If you press the Timer Button (main unit / remote control)
while the operation is stopped, "ON Timer" is set.
• ON Timer and OFF Timer cannot be set at the same time.
• The Plasmacluster Ion Generator releases a small trace of
ozone which may produce odor.
This is not detrimental to health.
• Clicking or ticking sound may be audible when the unit is
generating ions. (The interval of sound may change.)
You may feel the sound becomes large or small depending
on use environment or operation mode, but it will not be
affected the effectiveness of Plasmacluster ion.
• Dust may block the ¿ lter, clean the ¿ lter. (See E-13)
After cleaning the ¿ lter, press the Filter Reset Button for at
least 3 seconds.
E-19
IG-ETC1A/E
WHAT TO DO