Sharp IG-ETC1A Operation Manual page 36

OPERATION
Ion mode operation
1
Main unit
ION MODE
Beep
Beep
Beep
Cool Wind Ion Mode
• Usually, use the product in the Cool Wind Ion Mode.
Room Cleaning Mode
• The disquieting air in the room can be effectively puri¿ ed. The product is not equipped with a function
that removes dust or pollen.
• The product is operated with energy-saving rhythm wind, horizontal swing angle 90 degrees, and
vertical swing ON at air volume level "7" and the operation is stopped 1 hour later.
Clothes Deodorizing Mode
• By applying the wind, the odor of half-dried clothes, which are dried in the room is deodorized to the
level enough to be ignored by the effect of Plasmacluster*. (*: Boken Quality Evaluation Institute, Japan)
• The product is operated with continuous wind, horizontal swing angle 60 degrees, and vertical swing
ON at air volume level "8" and the operation is stopped 2 hours later.
Sensor Mode
• The air volume level is automatically increased or decreased by 1 level according to temperature or
humidity in the room.
• If the room becomes dark, the air volume level is automatically decreased by 1 level and the
Plasmacluster Ion Sign goes out, and then the Air Volume Indication Light becomes dark.
Note:
• Please set the main unit before operation, in order to let the wind blow directly to the clothes and
even the place which contains bad odor. If you set the main unit in front of the target object, the
deodorizing function can be carried out effectively.
• Air volume, Air volume ¿ ne adjustment, Energy-saving rhythm wind, Timer, and Swing angle can
be changed during the operation in Room Cleaning Mode or Clothes Deodorizing Mode, however,
the mode would be changed to the Cool Wind Ion Mode automatically.
Note on Auto Restart function
During operation, if the AC adapter is pulled out or circuit breaker trips, or power failure, the ion
generator will resume operation in precious mode.
To set
Press the Air Volume Fine Adjustment Buttons
while the operation is stopped.
The buzzer sounds "Beep" and the setting is turned ON. All lamps light up for 10 seconds.
To cancel
Press the Air Volume Fine Adjustment Buttons
while the operation is stopped.
The buzzer sounds "Beep Beep" and the setting is turned OFF.
Note:
• The Auto Restart function is preset to OFF when the product is shipping out from the factory.
During operation, select your favorite
Remote control
Ion mode.
• There are 4 modes shown below.
ION MODE
Beep Beep
on the main unit at the same time for 3 seconds
on the main unit at the same time for 3 seconds
E-12
Beep