How To Replace The Plasmacluster Ion Generating Unit; Specifications - Sharp IG-ETC1A Operation Manual

HOW TO REPLACE THE PLASMACLUSTER ION GENERATING UNIT

Remove the air suction
1
port cover.
Air suction port cover
Fully insert a new
2
Plasmacluster Ion
Generating Unit.
Insert the AC Adapter in an outlet and press the Operation Button.
3
Check the Unit Replacing Light is OFF.
Note:
• The unit holder can be opened by 45 degrees only. If you open if forcibly, it may be damaged.

SPECIFICATIONS

Model
Power source system
Power input
Power output
*
Applicable À oor area
Air volume ¿ ne adjustment
Power Consumption
Operating noise level
Dimensions
Weight
Cord length
*
The target À oor area where 25,000 ions/cm
of room (1.2m in height from À oor) by placing this product against a wall when the wind volume is the
maximum (without vertical or horizontal swing).
Clip the upper and lower
hooks and open the unit
holder.
Hook
Unit holder
Close the unit holder.
IG-ETC1A: AC 220V, 0.9A, 50Hz
IG-ETC1E: AC 220-240V, 0.9A, 50/60Hz
2
( )
m
(level) 1 (Min.)
(W) 2.0
( dBA)
17
(mm) 240 (W) x 240 (D) x 870 (H)
(kg)
(m)
3
blasted out in the room can be measured near the center
E-18
Fix the unit holder with
a hand and pull out
the Plasmacluster Ion
Generating Unit.
Plasmacluster Ion
Generating Unit
Attach the air suction port
cover.
IG-ETC1A/IG-ETC1E
AC Adapter
DC 12V, 2.5A
19.83
32 (Max.)
24.0
45
Approx. 4.0
Approx. 1.8