Sharp IG-ETC1A Operation Manual page 33

Plasmacluster ion generator
Table of Contents

Advertisement

Adjust the vertical swing angle
(When the vertical swing operation OFF)
1
Main unit
Beep
2
Beep
Beep
Note:
• Do not move the louver with your hands.
• Do not touch the moving louver.
Power OFF
1
Main unit
Beep
POWER
Memory function
If the operation is stopped by the Operation Button on the main unit or the remote control,
the operation status of Cool Wind Ion Mode and Sensor Mode is memorized.
• The settings of Timer, Room Cleaning Mode and Clothes Deodorizing Mode are not memorized.
• After electric power failure or AC adapter is pulled out, the memorized content is deleted.
(Excluding the case when the operation automatic recovery function is set) (See E-12)
Note:
• With this product, horizontal / vertical swing angle cannot be adjusted manually.
Be sure to adjust them with main unit or remote control.
• The operation may temporarily stop when the operation range becomes the maximum during swing
or louver operation, however, it is not a troubleshooting.
• If the swing does not operate in 2 seconds or more after vertical or horizontal swing is turned ON,
pull out the AC adapter from an outlet immediately and contact the distributor you purchased the
product.
Press the Vertical Swing Button.
Remote control
• Every time when you press the Vertical Swing
Button, the louver operation switches to "ON"
or "OFF".
• The vertical swing starts at 40 degrees upward.
Press the Vertical Swing Button to
stop the swing when the louver comes
to your favorite position.
Press the Operation Button.
Remote control
• The operation stops after all lights go out and
the louver blocks the outlet port.
POWER
E-9
IG-ETC1A/E

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ig-etc1e

Table of Contents