Connecting To The Server Module; Connecting Through The Chassis Cmm Ethernet Port - Sun Oracle Sun Blade T6340 Installation And Administration Manual

Connecting to the Server Module

This section describes how to connect to the server module SP using one of the
methods listed below and described in the corresponding sections:
Connect to the CMM SP Using Ethernet Port NET MGT 0. Use the CMM service
■
processor proxy and the command line interface to navigate to the Sun Blade
T6340 server module SP ILOM firmware. You can also use the CMM SP web
interface to control the server module (Items 1 through 3 in
method is described in this getting started guide. See
Chassis CMM Ethernet Port" on page
Connect to the CMM serial connector (SER MGT). Use the CMM SP proxy to
■
navigate to the server module SP ILOM firmware. This method supports CLI
access only (Item 6 in
Through the Chassis CMM Serial Connector" on page
Use a dongle cable to connect directly to the server module SP with an RJ45
■
serial connection. This method supports CLI access only (Items 7 and 9 in
). Dongle cables are intended for setup, testing, or service purposes and
FIGURE 2-2
should be removed when not in use. See
Using a Dongle Cable" on page
Use a dongle cable to connect directly to the server module host with a local
■
keyboard, video, and mouse (local KVM). (Items 8 and 9). See
the Server Module With a Local Graphics Monitor or Local KVMS" on page
Connect to the server module SP using the Ethernet (DHCP or static). This
■
method supports a CLI, or a web interface. The web interface can also control the
server module host using a remote keyboard, video and mouse (remote KVM).
(Items 1 through 3 in
Connecting Through the Chassis CMM Ethernet
Port
The Ethernet port on the modular system chassis provides the most robust method
of connecting to the CMM and the server module SP. This connection supports both
the CLI and the web interface.
You can connect to the CMM through the RJ-45 NET MGT 0 Ethernet port.
Before you can use the Ethernet connection, you must know the IP addresses for the
CMM and server module SP to which you want to connect. To configure the IP
address on the Sun Blade T6340 server module, refer to
the IP Address for a Server Module SP" on page
13.
). See "Connecting to the Server Module SP
FIGURE 2-2
"Connecting to the Server Module SP
19.
).
FIGURE 2-2
Chapter 2
FIGURE 2-2
"Connecting Through the
16.
"Connecting to
"Configuring and Viewing
20.
Installation and Configuration
). This
29.
13