Interface Box Connections - Bosch AUTODOME 7000 VG5-7230 Operation Manual

62 en | Installing the In-Ceiling Mount
Figure 10.6: Alarm and relay connectors
1
Pin Description
1
2
3
4
For in-ceiling mount only: Low Voltage TTL (3.3V) can also be used.
4
1.
2.
9.6

Interface Box Connections

The following figure is a detailed illustration of the In-ceiling Interface box.
2014.04 | 2.0 | F.01U.283.679
PIN
1
2
3
4
PIN
1
2
3
4
5
6
4-pin Alarm 2
Connector (P102)
Pin
Alarm Out 1 1
Alarm Out 2 2
Alarm Out 3 3
Alarm Ground 4
5
6
Connect the plugs to their mating connectors P103 and P102 in the Interface Box.
To connect supervised alarms and relays, attach the appropriate wires to their terminals
on the P104 connector on the Pipe Interface Board. Refer to the Connection, page 71
chapter for more details on wiring alarms.
Attach the lid to the Interface box:
Align the slots on the lid with the two posts at the rear of the Interface box.
Rotate the lid down.
Squeeze the ground clips, located at the front of the box, against the Interface box with
your fingers before closing the lid to ensure that the lid does not catch on the ground
clips.
Secure the lid to the Interface box by pushing the lid down until the clip on the lid
catches against the box.
WHITE
BROWN
ORANGE
GREEN
WHITE
BROWN
ORANGE
GREEN
YELLOW
BLUE
6-pin Alarm In
Connector (P103)
Description
Alarm in 3
Alarm in 4
Alarm in 5
Alarm in 6
Alarm in 7
Alarm Ground
Operation Manual
P102
P103
3 7-pin Relay Connector (P104)
Pin Description
1 Alarm Out 4 Normally Open
2 Alarm Out 4 COM
3 Alarm Out 4 Normally Closed
4 Earth Ground
5 Analog Alarm 1
6 Analog Alarm 2
7 Ground
Bosch Security Systems, Inc.
AUTODOME 7000
1
2
3
4
5
6
7
P104