Secure Housing To Ceiling - Bosch AUTODOME 7000 VG5-7230 Operation Manual

AUTODOME 7000
Caution!
The In-ceiling dome is provided with tether points on each side of the housing. To prevent
!
injury, attach a safety wire from a secure anchor point above the ceiling to a tether point on
the dome housing. See below for an illustration.
9.9

Secure Housing to Ceiling

The In-ceiling Housing is secured to the ceiling by two (2) screw clamps.
1.
2.
6.5 mm
0.26 in.
MINIMUM CEILING
Figure 10.11: Secure camera to ceiling
1
2
3
Caution!
Over-torquing the Ceiling Clamps can damage the clamp or ceiling. Only tighten the clamp
!
until it contacts the ceiling and you start to feel some resistance. If using a power
screwdriver, set the torque level to the lowest setting.
Bosch Security Systems, Inc.
Insert the In-ceiling Mount Assembly through the hole in the ceiling.
Tighten both clamps using a #2 Phillips screwdriver, to secure the housing to the ceiling.
mm
inches
Tether Point
Ceiling Clamp
Tether Point
40 mm
1.57 in.
MAXIMUM CEILING
4 Ceiling Clamp
5 Rotate Clockwise to Engage Clamp
Operation Manual
Installing the In-Ceiling Mount | en
2014.04 | 2.0 | F.01U.283.679
67