Installing The Vga-Roof-Mount - Bosch AUTODOME 7000 VG5-7230 Operation Manual

48 en | Installing the Roof Parapet and Pipe Mounts
4.
Notice!
After all wiring is complete, close the cover door and tighten the two (2) captive screws on
the cover door to 10-12 N-m (90-105 in.-lbs) to ensure the Power Supply Box is watertight.
8.4

Installing the VGA-ROOF-MOUNT

This section details the installation steps for the Roof Parapet Mount. If you are installing a
pipe mount, refer to Installing the VG4-A-9543 Pipe Mount, page 50 for instructions.
Figure 9.6: VGA-ROOF-MOUNT
1.
Notice!
Allow enough room below the Parapet Mount Bracket to route the video, control and alarm
wires up through the Parapet arm. In certain installations you may have to lift the Parapet arm
for the camera to clear the top of the wall when it is swung into position. Provide enough
slack in the wires to rotate the pipe arm over the roof and back when camera maintenance is
required.
2.
Figure 9.7: Parapet Wall Mount Bracket and Roof Mount Plate
1
2
3
2014.04 | 2.0 | F.01U.283.679
When the hinges are aligned, release the top hinge pin to engage its mating hinge on the
power box. Then release the bottom hinge pin from the Hinge Pin Stop to complete
attaching the Cover Door to the Power Supply Box.
Determine the wall location on the roof for the camera and use the Parapet wall mount
bracket as a template to mark the hole locations.
Prepare the mounting surface for the type of fastener by drilling holes for the mounting
anchors as required.
Pipearm
Parapet Wall Bracket
3/8-16 SS Hex Head Bolt
(supplied)
4 Apply sealant around each fastener hole
5 Roof Mount Plate
6 Use a minimum of six (6) fasteners (not
supplied). Eight (8) fastener holes shown.
Operation Manual
AUTODOME 7000
Bosch Security Systems, Inc.