Table of Contents
Advertisement
50
en | Installing the Roof Parapet and Pipe Mounts
Figure 9.9: Attach Dome Cap
1
2
11. Run a bead of RTV Silicon sealant around the down pipe/Dome Cap interface to seal any
12. Proceed to Wire the Pipe Interface Board, page 52.
Notice!
Use a guy-wire to aid in stabilizing the Parapet Arm. Replace the 1/4 inch cap screw with a
threaded 1/4-inch stainless steel eye bolt (not supplied). Loop the guy-wire through the eye
bolt and attach both ends to anchor spots on the roof.
8.5
Installing the VG4-A-9543 Pipe Mount
This section details the installation steps for the VG4-A-9543 Pipe Mount. If you are installing
the Roof Parapet mount, refer to Installing the VGA-ROOF-MOUNT, page 48 for instructions.
Notice!
Customer must supply 1-1/2 inch (NPS) pipe threaded on both ends with a minimum length
of 5 inches (12.7 cm).
You must use Teflon tape for thread-sealing compound.
All screws shall be tightened securely.
2014.04 | 2.0 | F.01U.283.679
Thread Sealant or tape
Dome Cap
gaps between the down pipe and the Dome Cap.
Operation Manual
AUTODOME 7000
Bosch Security Systems, Inc.
Hide quick links:
Advertisement
Table of Contents
