Lens Settings - Bosch AUTODOME 7000 VG5-7230 Operation Manual

AUTODOME 7000
–
Night mode threshold
Adjusts the level of light at which the camera automatically switches out of night mode (B/W)
operation. Select a value between 10 and 55 (in increments of 5), where 10 is earlier and 55 is
later.
Noise Reduction
Turns on the 2D and 3D noise reduction feature.
Noise Reduction Level
Adjusts the noise level to the appropriate level for shooting conditions. Select a value between
1 and 5.
Anti-fog
Select Auto to configure the camera for automatic Anti-fog mode, which activates when the
video analytics in the camera detect fog and add light to the video image (and then
deactivates when the fog clears or the scene changes).
Select On to activate Anti-fog mode on a continuous basis. The camera operates in this mode
until a user deactivates the mode. The video image on the LIVE page may become lighter.
Select Off to deactivate the mode. The video image on the LIVE page may become darker.
14.16

Lens Settings

Autofocus
Continuously adjusts the lens automatically to the correct focus for the sharpest picture.
–
–
–
Focus polarity
–
–
Focus speed
Use the slider (from 1 to 8) to control how fast the Auto focus will readjust when the focus
becomes blurred.
Auto iris
Automatically adjusts the lens to allow the correct illumination of the camera sensor. This type
of lens is recommended for use where there are low light or changing light conditions.
–
–
Iris polarity
Capability to reverse the operation of the iris button on the controller.
–
–
Auto iris level
Increases or decreases brightness according to the amount of light. Type a value between 1
and 15.
Bosch Security Systems, Inc.
Auto (default): The camera switches out of Night Mode after the ambient light level
reaches a pre-defined threshold.
One Push (default; commonly called "Spot Focus"): activates the Auto Focus feature after
the camera stops moving. Once focused, Auto Focus is inactive until the camera is moved
again.
Auto Focus: Auto Focus is always active.
Manual: Auto Focus is inactive.
Normal (default): focus controls operate normally.
Reverse: focus controls are reversed.
Constant (default): camera constantly adjusts to varying light conditions (default).
If you select this option, the camera makes the following changes automatically:
– Gain Control: switches to AGC.
– Shutter Speed: switches to default.
Manual: camera must be manually adjusted to compensate for varying light conditions.
Normal (default): iris controls operate normally.
Reverse: iris controls are reversed.
Operation Manual
Configuration via IP, Advanced Mode | en
2014.04 | 2.0 | F.01U.283.679
103