2. Installation
2.1
Installation and Connection
2.1.1
Connecting & Running
2.1.1.1
Connecting camera
Connect CCTV camera to DVR with BNC cable as below
- The video type for all channels should be either NTSC or PAL, not be combined both
- DVR sets video signal's impedance (75Ω) automatically. Impedence is set as 75 Ω basically. If
connecting a dvice to video output, impedance will be "Hi-z" status.
- Video Type (NTSC/PAL) should be changed after booting DVR. The order of camera
recognition follows ch1 through Ch16 camera amd 1
camera type.
2.1.1.2
Connecting monitor
Connect CCTV monitor to DVR with BNC cable as below.
Will be able to connect BNC, DVI and VGA.
2.1.1.3
Connecting Audio
Connect audio signal to DVR with using RCA cable or D-SUB as below;
[EH-Series]
[EH-Series]
st
recognized camera type leads other
[LH-Series]
23
Install&User Manual
[LH-Series]