A6
INSTALLATION MANUAL
CHANNEL BRIDGE MODE Setting
The Channel Bridging buttons for the A6 are located on the back panel next to the Line Outputs. These recessed
buttons are located beneath a decal. Using a small Phillips screwdriver carefully pierce the decal to access the but-
ton. The buttons are Factory Defaulted in the OUT (OFF) position. Audio signals connected to the # 1 & 3 & 5 chan-
nels of the A6's LINE INPUT will be routed to the top row of speaker outputs. See Figure 2-9: 3 Channel Bridged for
more details.
• Channel 1 & 2 Positive (+) Binding Post terminals become the bridged Output of Channel 1.
• Channel 3 & 4 Positive (+) Binding Post terminals become the bridged Output of Channel 3.
• Channel 5 & 6 Positive (+) Binding Post terminals become the bridged Output of Channel 5.
+
Positive
Terminals
Page 20
1 + 2
3 + 4
Bridge
Mode
Buttons
Figure 4-3: A6 Channel Bridge Mode Buttons
E L A N H O M E S Y S T E M S
Speakers
8 Ohm
Minimum
Speaker
Binding
Post
5 + 6
© ELAN Home Systems 2009 • All rights reserved.