Troubleshooting Guide - Centurion R3 User Manual

Troubleshooting Guide

Troubleshooting Guide
This is a basic checklist for your gate automation system. Should you experience a fault with the system,
see if the symptom corresponds to any given in the list below. For each symptom listed, the probable
cause and action to be taken is given. In the event of the symptom not being listed, consult your installer
for assistance.
CAUTION
NB: As this product is used outside of the control of the manufacturer, CENTURION SYSTEMS
(PTY) LTD, it cannot be held responsible for consequential damage as a result of the end user
attempting to maintain the unit without the assistance of a qualified installer.
SYMPTOM

Gate does not open or close
fully or gate moves a short
distance and stops.
PRIOR TO WORKING INSIDE THE CONTROL CARD ENCLOSURE, ENSURE
THAT THE MAINS SUPPLY TO THE SYSTEM HAS BEEN ISOLATED.

There is an object obstruct-
ing the movement of the gate.

Anti-crushing device setting
is too sensitive

Position control system is
malfunctioning.

Battery voltage is low and the
battery protection is being
activated.
CAUSE
Page 19
ACTION

INDICATION: STATUS LED
will be flashing 4 times per 2
seconds.

Clear any obstructions from
the gate.

Unhook the gate from the
m e c h a n i c a l l i n k a g e a n d
check that the motor operates
c o r r e c t l y. C o n s u l t y o u r
installer should there still be a
problem.

C h e c k t h a t t h e s e n s o r
m o u n t e d a d j a c e n t t h e
geared DC motor is clipped
into position. Check both
MASTER and SLAVE motors
where applicable.

INDICATION: STATUS LED
will be flashing 3 times per 2
seconds.

Check that the battery is
charging.

Check that the mains supply
is connected and switched
on.

Touch the side of the charger
unit, it should be hot if the
battery is charging.

Check battery connections
are tight and that there is no