Table of Contents
Advertisement
1.6. WPS
Use the unique WPS (Wi-Fi Protected Setup) function to insure
your wireless security, and you may complete the setup of wireless
configuration and encryption within a simple click on a button. However,
this function only works on Windows 2000 and XP OS.
●WPS：Click this check box to enable the Wi-Fi Protected Setup function.
●WPS Status：This shows the status of the WPS is either "Configured"
or "UnConfigured".
●Self-PIN Number：Click the "Regenerate PIN" to regenerate a PIN
number for your BLW-54CW3. Only devices that share the same PIN
Number can be connected wirelessly.
●Push Button Configuration：Click the "Start PBC" button to start
WPS configuration automatically. After you click the "Start PBC"
button, you have to go to the WPS station side and push its WPS button
within 2 minutes.
●Apply Changes：Click this button to save the settings and restart the
router.
●Reset：If there is anything wrong with the settings you made, you can click
"reset" to configure the page again.
●Current Key Info：This table shows devices that are currently connect.
●Client PIN Number：You can enter the WPS client PIN number here
to start PBC connection as well. After clicking the "Start PIN" button,
you have to go to the WPS station side and push its WPS button within 2
minutes.
※Note：You can also click the button on the rear panel of BLW-
54CW3 to start PBC connection as well.
Chapter3 Advanced Setup & Configuration
3
65
Advertisement
Table of Contents
