Table of Contents
Advertisement
2
Basic Setup & Configuration
1. Client's Computer Setup
The computers on your LAN need to be set up to cooperate with BLW-
54CW3 Wireless Router.
Please make sure that your operating system already enabled your interface
card on the host and connected to one of the LAN ports on BLW-54CW3
through Cat.5 cable. Be sure that LEDs on
on and the LED corresponds with the port which you connected. If you
switch on BLW-54CW3 for the first time, owing to the default status, it
will automatically enable the embedded DHCP server and start to distribute
IP to your host. In addition, the default IP address of BLW-54CW3 is "
192.168.1.1." If your operating system is Windows 98/2000/XP, you may
be able to use command of "ipconfig" to inquire whether you have the
correct IP address or not. If you are using Linux/Unix-Like system, you
can use "ifconfig" to check your NIC (Network Interface Card) address.
The instructions are as follows:
●Windows98
1.Click "Start→Programs→MS-DOS" or "Start→Run..." and
type in "command.exe" and then press enter.
2."MS-DOS" window will appear.
3.Type "ipconfig" after the command of "c:>" and then press enter.
4.MS-DOS will appear your NIC address in the window, please take
notice of the value of "IP Address" and "Default Gateway."
5.The value of "Default Gateway" is the IP address of BLW-54CW3.
BLW-54CW3 are already
Chapter2 Basic Setup & Configuration
2
Advertisement
Table of Contents
