Volkswagen Type II Transporter 1200 Series Shop Manual page 61

i i i f · - - - -
CARBURETTOR BODY
~
IDLINGJET
Fuel System-7
SPRING
"I'
aiD
~
I
DIAPHRAGM
LINK SPRING
THROTTLE LEVER PUMP LEVER
(5) From the carburettor, disconnect the vacuum pipe.
(6) Detach the accelerator cable from the throttle lever
and take out the spring, washer and cable swivel pin.
(7) Undo the carburettor mounting nuts from the studs
and remove the carburettor.
TO INSTAL
Installation is a reversal of the removal procedure
observing the following points:
(I) Instal a new gasket between the carburettor and the
intake manifold flange.
(2) To connect the accelerator cable on the throttle
lever, first open the throttle lever to provide a .040"
clearance between the throttle lever and the carburettor
body stop in nearly wide open position. Press the
accelerator pedal down to the limit of its travel and connect
the cable to the throttle lever. Ensure that all other linkages
are installed free of play and without strain.
(3) The intake elbow securing screw must not be
tightened in excess of reasonable limits.
VACUUM ADVANCE PIPE
THROTTLE SHAFT AND LEVER
Accelerator Pump Components of 28 PICT Carburettor.
( 4) Do not overlook connecting the heater element
pipe to the air cleaner intake tube.
(5) Always adjust the idling speed when the engine is at
operating temperature.
TO DISMANTLE
(I) As previously described, remove the carburet tor.
(2) Separate the upper and lower portions of the
carburettor by removing the five securing screws.
.6 COver Calibrations for Automatic Choke Adjustment .
.... Left Hand Side View of 30 PICT-2 Carburettor. (1600
models typical also of 30 PICT-1 Carburettor fitted to 1500
models.)
61