Volkswagen Type II Transporter 1200 Series Shop Manual page 232

9-Body
Removing Wind-up Door Glass on Later Models.
TO INSTAL
(1)
Clean any sealer from both the weatherstrip and
the glass.
(2) Fit the weatherstrip to the glass ensuring that the
moulded corners are in correct position.
(3) Insert a suitable cable approximately .125"
diameter in the interior side outer rubber channel leaving
sufficient exposed at one end to provide a firm grip.
(4) Apply pressure from the outside inwards and at the
same time slowly pull the cable back against and out of the
weatherstrip and progress around the glass, bumping the
glass gently with either the hand or a soft rubber mallet as
the lip of the strip curls over the flange.
NOTE: The removal and installation of the rear door and
other windows are identical with the foregoing operations.
TO REMOVE VENT WING GLASS (CABIN DOORS
Hinged Type)
(1)
Remove the rivet from the upper hinge bracket.
(2) Tilt the window outwards and lift the spindle out
of the clamp.
TO INSTAL
(1) Place the spindle in the clamp and position the vent
wing, re-rivet the upper hinge bracket. ··
(2) Remove the ·(I..,of trim where applicable and adjust
the spindle clamp by · tightening the screw which is
accessible through a hole in the door frame panel. The
tensipn should be firm but free.
(3) Lubricate the spindle with a small application of
grease.
232
TO
~EMOVE
QUARTER GLASS (Front Door Fixed)
(1)
Remove the door handles.
(2) Remove the door trim panel as previously
described.
(3) Remove the screw from the bottom of the quarter
glass frame support through the hole provided in the door
panel located just to the rear of the regulator handle.
( 4) Remove the two screws securing the door glass
metal channel to the lifter cable bracket and allow the door
glass to rest on the bottom of the door.
(5) Pull down the channel at the point where it meets
the quarter glass frame at the top of the door frame and
remove the screw from the bracket revealed.
( 6) Pull the quarter glass frame towards the rear of the
vehicle and slightly downwards at the same time and
manipulate the frame runner from the door by lifting the
assembly upwards and out of the door frame.
TO INSTAL
Installation is the reversal of the removal procedure.
TO REMOVE SLIDING DOOR VENT GLASS
(1)
The vent glass can only be removed complete with
the frame and this operation can be facilitated by prior
removal of the large window.
(2) Straighten the two metal tongues connecting the
vent glass frame to the inside edge of the door which are
revealed by lifting the inside edge of the weatherstrip.
(3) Press outwards on the wing glass and remove th,e
assembly complete with weatherstrip.
(4) Remove the Philips head screw from the pivot
sh~ft