Volkswagen Type II Transporter 1200 Series Shop Manual page 237

(6) Remove the four Philips screws and detach the lock
by withdrawing out and downwards to clear the lock
connecting link.
(7) Remove the two Philips screws attaching the
central lock to the door face and single Philips screw
attaching the lock to the door inner panel and remove the
central lock and two remote control rods from the door.
TO INSTAL MAIN AND CENTRAL LOCKS
(1) Ensure that the mechanism of both locks is clean
and lubricated.
(2) Check the rubber buffers of the main lock and the
retainer bracket.
(3) Position the main lock on the door face and inner
panel, passing the lock connecting link up through the small
aperture in the inner panel.
(4) Instal and tighten the four Philips screws to secure
the lock to the door.
(5) Position the safety lock assembly on the inner
panel, engaging the pin on the hole in the upper end of the
connecting link and secure the lock assembly with the three
Philips screws. Align the assembly bracket and tighten the
screws securely.
(6) Position the central lock on the opposite door face
and inner panel, hold the two remote control rods in a
horizontal position, instal and tighten the three Philips
screws.
{7) Connect each remote control rod to its respective
bar on the main lock and use the following procedure to
adjust the rods.
Internal View of Central Lock Assembly.
237
Body-14
MAIN LOCK ASSY
Sliding Door Remote Control (Main) Lock and Retainer
Assembly.
Sliding Door Main Lock viewed from Interior of Vehicle.