Toshiba RAS-B10GKVP-E Service Manual page 82

Block distinction
Check Check
Block
code code
Outdoor
P .C. board
Not
displayed
Outdoor
P .C. board
Others
(including
compressor)
Operation of diagnosis function
Cause of operation conditioner
status
Inverter over-current All off
protective circuit
operates. (Short time)
Position-detect circuit All off
error or short-circuit
between windings of
compressor
Current-detect circuit All off
error
Being out of place, All off
disconnection or short-
circuit of the outdoor
temp. sensor (Ts)
Disconnection or short- All off
circuit of discharge
temp. sensor
Outdoor fan drive All off
system error
Outdoor temp. sensor Operation
error
continues
Compressor drive
All off
output error,
Compressor error
(lock, missing, etc.),
Break down
Return serial signal has Operation
been sent when
continues
operation started, but it
is not sent from halfway.
1) Compressor thermo.
operation Gas
shortage Gas leak
2) Instantaneous power
failure
Compressor does not All off
rotate. (Current
protective circuit does
not operate when a
specified time passed
after compressor had
been activated.)
Discharge temp. All off
exceeded 117°C
Break down of All off
compressor
– 82 –
Air
Remarks
Displayed when
error is detected.
Displayed when
error is detected.
Displayed when
error is detected.
Displayed when
error is detected.
Displayed when
error is detected.
Displayed when
error is detected.
——
Displayed when
error is detected.
Flashes when
trouble is detected
on return serial
signal, and normal
status when signal
is reset.
Displayed when
error is detected.
Displayed when
error is detected.
Displayed when
error is detected.
Judgment and action
Even if trying operation again,
all operations stop immediately. :
Replace P .C. board.
1. Even if connecting lead wire of
compressor is removed,
position-detect circuit error
occurred. : Replace P .C. board.
2. Measure resistance between
wires of compressor, and
perform short-circuit. :
Replace compressor.
Even if trying operation again, all
operations stop immediately. :
Replace P .C. board.
Check 5-serial LED.
1. Check sensors (TE, TS).
2. Check P .C. board.
1. Check discharge temp. sensor
(TD).
2. Check P .C. board
Position-detect error, over-current
protective operation of outdoor fan
drive system, fan lock, etc. :
Replace P .C. board or fan motor.
1. Check outdoor temp. sensor
(TO).
2. Check P .C. board.
Check 5-serial LED.
When 20 seconds passed after
start-up, position-detect circuit error
occurred. : Replace compressor.
Trouble on P .M.V.
1. Repeat Start and Stop with
interval of approx. 10 to 40
minutes. (Code is not displayed
during operation.)
Supply gas.
(Check also gas leak).
2. Unit operates normally during
check.
If return serial signal does not
stop between indoor terminal
block 2 and 3, replace inverter
P .C. board.
If signal stops between indoor
terminal block 2 and 3, replace
indoor P .C. board.
1. Trouble on compressor
2. Trouble on wiring of compressor
(Missed phase)
1. Check dischage temp. sensor
(TD).
2. Gas leakage
3. Trouble on P .M.V.
1. Check power voltage.
(220–230–240 V +10%)
2. Overload operation of
refrigeration cycle
Check installation condition
(Short-circuit of outdoor diffuser).