Toshiba RAS-B10GKVP-E Service Manual page 127

Appendix
4. Cord heater installation work procedure
No. Photo / Explanatory diagram
Remove each cabinet, inverter assembly, motor base assembly, and partition board assembly.
1
∗ Do not damage the electric parts such as cables, connectors, etc. while this work
1-1
1-2
Side cabinet (L)
1-3
1-4
Upper cabinet
Valve cover
Water-proof
cover
Wiring cover
Front cabinet
Inverter assembly Side cabinet (R)
Appendix-4
Procedure
Remove the upper cabinet and the valve cover.
Related parts / Screws list
Part name
Screw type
Upper cabinet
Valve cover
Remove the front cabinet, the wiring cover and the
water-proof cover.
Related parts / Screws list
Part name
Screw type
Front cabinet
Wiring cover
Remove the side cabinet (R/L) and the inverter assembly.
Related parts / Screws list
Part name
Screw type
Side cabinet (R)
Side cabinet (L)
Inverter assembly
Remove the inverter assembly.
No. Part name Connector No.
1 TE sensor CN600
2 TD sensor CN601
3 TO sensor CN602
4 TS sensor CN603
5 4-way valve coil CN701
6 PMV coil CN700
7 Fan motor CN300
Compressor (Intermediate
8
lead connector)
Reactor (Intermediate
9
(2 pieces.) connector)
Used screw
Quantity
Ø4 × 8 5
Ø4 × 1 1
Used screw
Quantity
Ø4 × 8 7
Ø4 × 8 2
Used screw
Quantity
Ø4 × 8 7
Ø4 × 8 3
Ø4 × 8 1
Connector color
White
White
White
White
Yellow
White
White
White
White