Toshiba RAS-B10GKVP-E Service Manual page 105

No. Part name
Fan 1) Follow to the procedure in the item
7
motor
2) Loosen the set screw of the cross flow fan.
3) Remove two fixing screws of the motor band
(Right), and then remove the motor band (Right).
4) Pull the fan motor outward.
In assembling work, install the fan motor as follows.
• When assembling the fan motor, the fan motor
• After assembling the two hooking claws of the
Cross 1) Follow to the procedure in the item
8
flow fan
2) Remove the heat exchanger fixing holder by
removing the two fixing screws used to secure it.
3) Loosen the set screw of the cross flow fan.
4) Lift the left side of the heat exchanger, and pull
out the cross flow fan.
Procedures
must be installed in such a way that the fan
motor leads will be taken out is positioned at
the bottom front.
motor band (right) into the main body, position
the fan motor, insert it, and then secure the
motor band (right) using the two fixing screws.
Fan motor leads
.
3
Secure using using
the fixing screw g screw
Screw
Motor band (Right) nd (Right)
Screw
Secure using sing
the fixing screw screw
.
6
– 105 –
Remarks
Set screw
Raise the
left side
Pull out here