Table of Contents
Advertisement
Interface Hardware (DKX-10 and DKX-19)
Cable Assemblies
These steps describe how to attach the rod end connector (515086) and stainless steel mechanical cable assembly
(116036) to the lock and Plate Assembly. It also describes how to connect the cable assembly, and adjust the cable length
to achieve proper timing of the high security lock bolt retraction relative to the Cylindrical lock latch.
14
Install Knob Lever Assembly
1. With the DKX Lock Assembly and the Cover Bracket (515034) successfully installed, the Knob Lever Assembly must be
attached.
2. Align the "Double D" Hole in the Knob Lever (515027) with the "Double D" protrusion on the Knob Assembly (116035), and
push the Lever Knob (515027, RH and RHR only) onto the Knob Assembly (116035).
3. Align the Screw Hole in the Manual Knob (515043) with the hole in the Knob Lever (515027, RH and RHR only), and hold
into slotted position.
4. Place the provided Screw (515044) through the Hole in the Manual Knob (515043) and screw the full Assembly into
position. Tighten to a minimum of 15 in.-lbs.
NOTE: For LH and LHR doors a geared cam assembly (514049 & 515104) is used (Figure 8) in place of the RH cam (515027).
RH and RHR shown.
(515104)_Knob Cam, Gear,
LH and LHR only
Reference - (515045_Nameplate),
Manual O/R Knob, DKX Series, -
Not Shown
See Instruction Step #21 (Last
Page) for Nameplate Installation
Document Number 548.0418 Rev. AX — 02/2019
Figure 6
(515043)_Knob, Over Ride,
DKX Series
(515044)_Screw), FH Phillips_#6-32 x .50,
#18-8 Stainless Steel
(116035)_Knob Asm., Panic Bar
(515027)_Lever,OverRide
CDX Cover Asm., DKX Series
19
Advertisement
Table of Contents
