THOMSON TR-069 Configuration Manual page 94

6| Service Provisioning
Message flow
Following illustration shows a possible message flow for the configuration of the NAT application list:
CPE
2) Apply changes
5) Apply changes
8) Apply changes
11) Apply changes
14) Apply changes
Example: parameter values
For example, following parameter values can be used:
Creating an
ObjectName argument the value
"InternetGatewayDevice.Services.X_000E50_NATApplicationList.Application.".
The AddObjectResponse
argument for example value "130".
Configuring the
following name-value pair in its ParameterList argument:
Name
InternetGatewayDevice.Services.X_000E50_NATApplicationList.
Application.130.Name
The parameter Name is mandatory. This means that the parameter must be set before the
Application object is internally created.
Creating a
argument the value
"InternetGatewayDevice.Services.X_000E50_NATApplicationList.Application.130.Rule.".
The AddObjectResponse
argument for example value "1".
88
Transaction session
...
1) AddObject
3) AddObjectResponse
4) SetParameterValues
6) SetParameterValuesResponse
7) AddObject
9) AddObjectResponse
10) SetParameterValues
12) SetParameterValuesResponse
13) SetParameterValues
15) SetParameterValuesResponse
...
application: the AddObject RPC
(message 3 in preceding illustration) contains for the InstanceNumber
application: the SetParameterValues RPC
rule: the AddObject RPC (message 7 in preceding illustration) contains for the ObjectName
(message 9 in preceding illustration) contains for the InstanceNumber
ACS
Create an Application
Configure the Application
Create a Rule (Port Mapping)
Configure the Rule (Port Mapping)
Assign a Host to an Application
(message 1 in preceding illustration) contains for the
(message 4 in preceding illustration) contains
Value
<Name>
E-DOC-CTC-20071119-0003 v1.0