THOMSON TR-069 Configuration Manual page 26

2| Configuring CWMP on the Thomson Gateway
CWMP connection request server
To display the default attribute values of the CWMP connection request server service, execute following
command:
=>:service system list name=CWMP-S expand=enabled
Idx Name
---------------------------------------------------------------------------------
1 CWMP-S
Description................ CPE Wan Management Protocol Server
Properties................. server
Attributes................. state port aclip aclif aclifgroup map log qoslabel
User Managed
Attribute Values :
State...................... (administratively) disabled
Port....................... 51005
QOS Label.................. None
Route Label................ None
NAT Portmap Weight ........ 30
Ip Access List............. any
Interface Access List...... any
Interface Group Access List any
Map List................... 51005
Logging.................... disabled
You can configure the value of following attributes:
State: by default, the CWMP connection request server service is disabled.
To enable the service, execute following command:
=>:service system modify name=CWMP-S state=enabled
Port: this attribute is the port on which the connection request server listens for connection requests. The
default port is 51005.
To assign another port number to the port, execute following command:
=>:service system modify name=CWMP-S port=51006
Log: this attribute is used to enable or disable service logging in the syslog message buffer. By default,
logging is disabled.
To enable logging of the service, execute following command:
=>:service system modify name=CWMP-S log=enabled
Natpmweight: the NAT portmap weight for the service. By default, this attribute has value 30.
To change the value of this attribute, execute following command:
=>:service system modify name=CWMP-S natpmweight=30
20
Protocol SrcPort
tcp
routelabel natpmweight
Attributes..... state port log natpmweight
DstPort Group
51005
E-DOC-CTC-20071119-0003 v1.0