THOMSON TR-069 Configuration Manual page 28

2| Configuring CWMP on the Thomson Gateway
SessionTimeout: this parameter is a number that specifies the HTTP session time-out in seconds (s).
When the CWMP client has received no HTTP messages from the ACS for this time period, the HTTP
session is closed.
By default, this time period is set to 60 s.
NoIpTimeout: this parameter is a number, specifying a time period in seconds (s). After the upload of a
new configuration file, it is possible that the modem can not reach the ACS any more. This means that
the IP connection is down. If this connection is not restored during the configured time period, a roll-back
mechanism is started and the initial configuration file is restored.
By default, the time period is set to 180 s (three minutes).
For more information on the roll-back mechanism, see
Mechanism" on page
MaxEnvelopes: this parameter specifies the maximum number of SOAP envelopes that the CPE accepts
in a single HTTP response. The value of this parameter can be 1 or 2.
By default, the number of SOAP envelopes sent within one HTTP response is limited to 2.
ConnectionRequest: if this parameter is enabled, the CWMP client establishes a connection to the ACS
when it successfully receives a Connection Request notification. These Connection Request notifications
also use HTTP. However, in this case, the ACS acts as the HTTP client and the Thomson Gateway acts as
the HTTP server.
By default, this parameter is disabled.
This parameter has the same value as the attribute
server service. For more information, see
ConnectionReqPath: this parameter specifies the path the ACS can use to reach the CWMP daemon on
the Thomson Gateway, for example for connection requests. It is used as last part of the
InternetGatewayDevice.ManagementServer.ConnectionRequestURL which is included in the
ParameterList of an Inform RPC.
The value of this parameter is only relevant if the parameter
ConnectionReqUserName: this parameter specifies a text string that must be used by the ACS as
username to log in. The value of this parameter is only relevant if the parameter
is enabled.
The default username is <OUI> - <serial number>. This can be achieved using CLI environment variable
concatenation. To retrieve this information, execute following commands:
=>:env get var=_OUI
000E50
=>:env get var=_PROD_SERIAL_NBR
CP0452JT03Y
ConnectionReqPsswd: this parameter specifies a text string that must be used by the ACS as password to
log in. The value of this parameter is only relevant if the parameter
ConnectionReqAuth: both HTTP basic and digest authentication can be used for connection requests.
The value of this parameter is only relevant if the parameter
parameter is used to select the authentication method to be supported.
None: the ACS asynchronous connection requests are not authenticated.
Basic: HTTP basic authentication is used.
Digest: HTTP digest authentication is used.
By default, HTTP digest authentication is selected.
22
42.
"2.2.1 CWMP Service Manager" on page
"3.2.1 Configuration Update
state
of the CWMP connection request
ConnectionRequest
is enabled.
ConnectionRequest
ConnectionRequest
ConnectionRequest
is enabled. This
E-DOC-CTC-20071119-0003 v1.0
19.
is enabled.