Table of Contents
Advertisement
10.
continued f rom page 10
Drain hose
Cut a 1-1/2" (3.8cm) diameter hole in
cabinet wall or floor on the side of the
opening closest to the sink.
Connect drain hose to waste tee or
waste disposer following one method.
11.
If youhave:
and:
an air gap
a wastedisposer
no air gap*
anair gap
nowastedisposel
noair gap*
*an air gapis recommended
gotostep:
11a.
11c.
11b.
11d.
11a.
1. Remove the disposer knockout plug.
Cut end of drain hose O if needed
(do not cut ribbed section).
2. Attach drain hose to air gap •
with
spring-type clamp O.
3. Use a rubber hose connector* •
with spring or screw-type clamps*
_) to connect air gap to disposer
inlet O.
This connection O MUST be before
drain trap _) and at least 20" (50.8cm)
above the floor where dishwasher will
be installed. Go to step 12.
11b.
1. Cut end of drain hose O if needed
(do not cut ribbed section).
2. Attach drain hose to air gap O with
1-!/2"-2" (3.8-5cm) screw clamp.
3. Use a rubber hose connector* •
with spring or screw-type clamps*
_) to connect air gap to waste tee _).
This connection _ MUST be before
drain trap (D and at least 20" (50.8cm)
above the floor where dishwasher will
be installed. Go to step 12.
11
Advertisement
Table of Contents
