Table of Contents
Advertisement
®
securepowersupplycouutu
dishwasher terminalbox.
q/power supply cord must plug into a
mating three-prong, grounded outlet,
located in the cabinet next to the
dishwasher opening. Outlet must
meet all local codes and ordinances.
Water
You must
have:
v' a hot water line with 20-125 psi
(138-862 kPa) water pressure.
v' 120°F (49°C) water at dishwasher.
o/3/8" O.D. copper tubing with
compression fitting (1/2" minimum
plastic tubing is optional but not
recommended).
v' a 90° elbow with 3/8" N.P.T.external
pipe threads on one end.
Do not solder within 6" (15.2cm) from
water inlet valve.
Drain
You must:
v' usea new 12feet (3.7m) maximum
drain hose that meets all current
AHAM/IAPMO test standards and is
resistant to heat and detergent.
v' have a high drain loop 20 inches
(50.8cm) above the subfloor or floor.
V' connect drain hose to waste tee or
disposer inlet above drain trap in
house plumbing and 20 inches
(50.8cm) minimum above the floor.
v' use an air gap if the drain hose is
connectedto house plumbing lower
than 20 inches (5O.8cm) above
subfloor or floor.
v' use 1/2" minimum I.D. drain line
fittings.
6
Advertisement
Table of Contents
