Important Safeguards - ElectrIQ AIRCUBE User Manual

Installation of window kit

Important safeguards

The length of the soft hose extends from 28 cm to 150 cm. If hose is extended above this length
the unit may malfunction and this can invalidate the warranty. Shorter the hose the better the
results, 40 cm is the ideal hose length for your AirCube. We recommend the outlet vent must be
well ventilated and not obstructed as this will cause the unit to overheat. Avoid bending the air
hose more than 30 degrees.
If you want to use the unit more than a spot cooler
we recommend to vent it out using the supplied
window kit. Partially open the window and then fix
the window kit to the window either horizontally
(fig.1) or vertically. Clip the other end of the hose
with the fishtail adapter to the air outlet of the
window slider.
Make sure the unit is upright and there are no
obstructions to the air inlets and outlet grills.
Note: The window kit is only designed to be installed with
sliding or sash windows or doors. The window kit is not made to be
used with any other style of windows. However the fish tail adaptor
can be used with most windows / doors but there will be an old air
escape making unit less efficient. When using the cooling mode ensure
that the opening left is as small as possible. The best form of
installation is through a wall duct.
In order to achieve a drop of temperature in the room, note that the
unit will need to be vented out, ideally through the wall. By properly
venting your air conditioner expels heat out of your room while
efficiently cooling it.
Page 6 of 16