ElectrIQ AIRCUBE User Manual page 9

swinging louvres and hot air coming through the back. Please note that in this mode the
temperature in the room will not be reduced. You may use the air conditioner in an open
vented fireplace as heat will raise from the back of the unit while cooling through the front.
We recommend venting the air conditioner with the vent kit supplier through the wall or
through the window and using it in a room of appropriate size.
Note: When in air conditioning please make sure the rubber water stopper (14) is in place
to ensure maximum cooling and efficiency. Your AirCube is an advanced self-evaporative air
conditioner, which reduces the need to empty the water tank in cooling mode. If the unit is
vented correctly most of the water is reused to cool the condenser coils and any excess is
evaporated. Please do not use continuous drainage if you intend to use the self-evaporating
facility for improved cooling effect.
DEHUMIDIFIER MODE
Select the dehumidifier mode from function button. The AirCube dehumidifier contains an
intelligent micro-computer that will ensure humidity is measured exactly and is able to
maintain a constant humidity dehumidifying with minimum energy expense.
When ambient humidity is lower than set humidity by 2%, compressor will stop
automatically for 3.5 minutes saving energy. The micro-computer will measure the
humidity and restart the compressor only the ambient humidity is higher than set humidity
by 2%.
HUMIDITY SETTINGS (HUM-, HUM+)
CO(continuous)→30%→35%→40%→45%→50%→55%→60%→65%→70%→75%→80%→8
5%→90%→CO
stops operating. Once the tank is full wait for another 30 minutes before removing it as
water may still defrost into the tank. Do not move the unit once the tank is displaced and
ensure rubber stopper in place to prevent water leaks. To resume operation insert the tank
back and press power button.
Note: When in dehumidifier mode remove the rubber water stopper (14) from drain.
Water will go in to the water tank (15). Permanent drainage and water pump can be
attached to the unit for unattended use. Occasionally the DF may appear on the LCD. The
dehumidifier is in defrost mode and normal operation will resume as soon as the defrost
cycle finishes. The lower the room temperature the more defrosting will happen.
Laundry mode: Set the humidistat to continuous mode or set
the range from 30%-50% and fan speed to maximum and
place within 1.5 meters from clothes / laundry dryer. Do not
place clothes directly over any of the AirCube's vents.
You can also install the hot air exhaust hose and direct it to
the spot you want to rapidly dry (e.g. plaster, clothes, shoes,
etc.). Make sure that there is nothing blocking the hot air
exhaust air flow.
On tank full the dehumidifier will stop operating. Do not
remove the water tank before is full and the dehumidifier
Page 9 of 16