Xerox DOCUPRINT N4525 Advanced Features And Troubleshooting Manual page 46

Control Panel Menus
Token Ring Menu Items (cont'd.)
Default Gateway Sets the four byte Default Gateway address. (This menu item only appears if
IP Address Res
Values:
Note: Once the control panel shows
use the Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address
Port Timeout Sets the time for determining when to end an incomplete print job and poll
the next port in the polling sequence. The timeout also causes an implicit job
end (such as Control D in PostScript or <ESC> E in PCL) and invokes the
emulation functions associated with this action (e.g., form feed, reset, etc.).
Values (in seconds):
The value changes by 1 each time you press either Value key (labeled 3 or 7).
Hold down either key to scroll quickly through the values.
Source Routing Sets the source routing option.
Values:
Speed Sets the default ring speed of the Token Ring interface.
Values (in MBits):
LAA Sets the six byte Locally Administered Address.
Values:
Note: Once the control panel shows
Value keys (labeled 3 or 7) to scroll to the desired value at the cursor
location. To move the cursor, use the Item keys (labeled 2 or 6). Thus, you
can change characters within the address rather than having to re-enter the
entire address.
30
is set to
xxx.xxx.xxx.xxx
where = to
xxx 000 255
- (default is )
5 300 60
(default)
Off
All
Single/All
Single/Specific
4
(default)
16
xxxx.xxxx.xxxx
where = to hexadecimal
xx 00 FF
where the range of
xxxx.xxxx.xxxx
through
4000 0000 0000
.)
static
Default Gateway
is from
.
7FFF FFFF FFFF
LAA on the top line, use the
DocuPrint N4525 Network Laser Printer
on the top line,