Xerox DOCUPRINT N4525 Advanced Features And Troubleshooting Manual page 107

Error Description and corrective action
Enter Password Appears when using the Password Menu to print or delete secure and proof
_xxx jobs. Jobs Print or Jobs Delete.
Enter a valid 4-digit password using the control panel's keys, then proceed
I
to print or delete the secure and proof jobs that have that password.
If you want to exit the Password menu, press the Menu keys (labeled 1 or 5).
I
To exit the menu system, press the On Line key (labeled 0).
Env. Feeder The Envelope Feeder is empty.
Empty
Refill the Envelope feeder if it is to be used again.
I
Env. Feeder Fail The 100 Envelope Feeder has failed so printing from it cannot continue.
Power Off/On
Power OFF the Printer, remove and re-install the Envelope Feeder, power
I
ON the printer.
If the Envelope Feeder still fails, contact your Customer Support Center.
I
Fan Failure The fan is not working.
Power OFF NOW!
Power OFF the printer immediately and contact your Customer Support
I
Center.
Finisher Failure Problem in the Finisher.
Power Off/On
Power OFF and ON the printer.
I
If the Finisher still fails, contact your Customer Support Center.
I
Flash Error A Flash Memory error was found.
Format Flash
Format flash memory as per the instructions on page 54.
I
If the problem persists, contact your Customer Service Center.
I
Flushing... Tells you that the PostScript print job could not be printed and is being parsed
Job name out and discarded. This message remains on the display until the job being
flushed is complete, which may require additional data to be sent from the
host. This may require resubmitting the job to the printer.
Format Failed A problem occurred during disk formatting. Printing may continue, but use of
Disk Locked the disk is locked out.
Try reformatting the disk again or replace it.
I
Fuser Fan The printer's fuser fan has failed.
Failure
Power OFF and ON the printer.
I
If this message reappears, Power OFF the printer and contact your Customer
I
Support Center.
Fuser Failure The Fuser has failed; printing cannot resume.
Power Off/On
Power OFF and Power ON the printer.
I
If the problem occurs again and you have just replaced the Fuser Cartridge,
I
reseat it.
If the problem occurs again and you have not replaced the maintenance kit,
I
it may be time to do so.
If the problem persists, contact your Customer Support Center.
I
Init Failed This disk cannot be initialized because it has been locked via a PJL command.
Disk Locked (It may be necessary to re-run the job without the lock command.)
Initializing... This message appears for a few seconds while the printer is initializing.
Wait.
I
Initializing... The printer is initializing the flash memory.
Flash Memory
Wait.
I
Advanced Features and Troubleshooting Manual
Control Panel Messages
91