Xerox DOCUPRINT N4525 Advanced Features And Troubleshooting Manual page 105

Error Description and corrective action
3000
-Enet A fault condition has occurred in the Ethernet interface.
Power OFF the printer, reseat the interface card, and then power ON the
I
printer.
If this code appears again at Power ON, contact your Customer Support
I
Center.
5000
-MEMORY A fault condition has occurred.
Power OFF and Power ON the printer.
I
If this code appears again at Power ON, contact your Customer Support
I
Center.
All Jobs Appears when using the secure print feature.
Delete
Press the Enter key (labeled 4) to delete all secure jobs in your queue.
I
Press the Value keys (labeled 3 or 7) to toggle between
I
All Jobs Appears when using the secure print feature.
Print
Press the Enter key (labeled 4) to print all secure jobs in your queue.
I
Press the Value keys (labeled 3 or 7) to toggle between
I
Canceling Job... Tells you that a job is being cancelled.
Job name
Check Verify that the stapler cartridge has been installed and is in position.
I
Staple Cartridge
Verify that the stapler cartridge contains staples.
I
Clear Area A Clear the paper jam in Area A at the Envelope Feeder or the Bypass Feeder
I
Reset Env/Bypass (see the Paper Jams section of the User Guide), then reset Env/Bypass.
Clear Area A Clear the paper jam in Area A (see the Paper Jams section of the User Guide),
I
Reset Tray 1 then reset Tray 1.
Clear Area B Clear the paper jam in Area B (see the Paper Jams section of the User Guide),
I
Reset Tray 2 then reset Tray 2.
Clear Area C Clear the paper jam in Area C (see the Paper Jams section of the User Guide),
I
Reset Tray 4 then reset Tray 4.
Clear Area C Clear the paper jam in Area C (see the Paper Jams section of the User Guide),
I
Reset Tray 5 then reset Tray 5.
Clear Area A,B Clear the paper jam in Area A and Area B (see the Paper Jams section of the
I
Reset Tray 2 User Guide), then reset Tray 2.
Clear Area A,B Clear the paper jam in Area A and Area B (see the Paper Jams section of the
I
Reset Tray 3 User Guide), then reset Tray 3.
Clear Area A,B,C Clear the paper jam in Area A, Area B, and Area C (see the Paper Jams section
I
Reset Tray 4 of the User Guide), then reset Tray 4.
Clear Area A,B,C Clear the paper jam in Area A, Area B, and Area C (see the Paper Jams section
I
Reset Tray 5 of the User Guide), then reset Tray 5.
Clear Area H The Finisher compiler tray (Area H) safety switch is on. Remove the obstacle
I
from Area H.
Close Door A Close Door A.
I
Close Door B Close Door B.
I
Close Door C Close Door C.
I
Close Door E Close Door E (the gate cover of the finisher).
I
Close Door F Close Door F (the transport cover of the finisher).
I
Advanced Features and Troubleshooting Manual
Control Panel Messages
and .
Delete Print
Delete and Print .
89