Removing The Rear Panel (Various Components And Lampholder); Removing The Terminal Board; Removing The Grill Heating Element; Removing The Spit Motor - Electrolux Built-in ovens Service Manual

4.2 - REMOVING THE REAR PANEL (various components and lampholder)

In order to remove the rear panel, simply remove the two upper screws.
Once the rear panel has been removed, the following components are accessible: the lampholder,
the grill heating element, the ignitor, the spit motor, the electronic board, the nozzle support and the
terminal board with cable clamp.
Fig. 283
1 - GAS INLET
2 - LAMPHOLDER
3 - GRILL HEATING ELEMENT
4 - SAFETY THERMOSTAT
5 - GAS SUPPLY PIPE
6 - IGNITOR
7 - INTERFERENCE SHIELDING
MAGNET

4.2.1 - REMOVING THE TERMINAL BOARD

To remove the terminal board, once you have removed the rear panel, please refer to chapter
2.4.4.

4.2.2 - REMOVING THE GRILL HEATING ELEMENT

To remove the grill heating element, once you have removed the rear panel, please refer to chapter
2.4.5.

4.2.3 - REMOVING THE SPIT MOTOR

To remove the spit motor, once you have removed the rear panel, please refer to chapter 2.4.7.
SOI 02.10 FV
8 - SPIT MOTOR
9 - ELECTRONIC BOARD
10 - TERMINAL BOARD
11 - INTERFERENCE FILTER
12 - CABLE CLAMP
13 - CONNECTOR CABLE
14 - GAS NOZZLE SUPPORT
137/142 599 70 59-01