Introduction; Purpose Of This Manual; Electric / Electronic Ovens; Dismantling The Built-In Oven - Electrolux Built-in ovens Service Manual

1 - INTRODUCTION

1.1 - PURPOSE OF THIS MANUAL

The purpose of this Manual is to provide a general outline of the methods of accessing the various
versions of ACCESS PLUS ovens. These accessibility descriptions set out the procedures for
removing the components. Follow the same steps in the reverse order to reposition the
components.

2 - ELECTRIC / ELECTRONIC OVENS

2.1 - DISMANTLING THE BUILT-IN OVEN

WARNING: Always disconnect the appliance from the power socket before accessing internal
parts.
Access to certain components is possible by pulling the oven partially out of the compartment (*).
With the oven partially pulled out, the service engineer can access the components in the front
panel and electronic control unit; for access to the other components located in the rear section, it is
necessary to remove the built-in oven completely from its compartment.
To remove the oven:
1. Remove the 4 screws, located at the front of the front panel, which secure the appliance to
the compartment (see Fig. 1 and 2)
Fig. 1
2. Remove the oven
(see Fig. 3).
Fig. 3
(*) N.B.: From January 2010 (serial number 001....) access to the top of the oven
has improved thanks to the progressive introduction of a one-piece top oven cover
(see chapter 2.6.1).
SOI 02.10 FV
Fig. 2
6/142 599 70 59-01