Disconnecting From The Power Supply; Removing The Control Panel; Removing The Bearing Control Panel - Electrolux Built-in ovens Service Manual

2.2 - DISCONNECTING FROM THE POWER SUPPLY

WARNING: Before accessing any of the components inside the oven, it is essential to disconnect
the oven from the power supply by removing the plug from the power socket or by turning the main
switch on the domestic circuit (if featured) to "OFF".

2.3 - REMOVING THE CONTROL PANEL

2.3.1 - REMOVING THE BEARING CONTROL PANEL

In order to remove the control panel (front panel), firstly remove the knobs and knob caps (where
featured).
1. Remove the upper panel (see chapter 2.6.2 on page 41).
2. Slide the knobs off the control components.
Fig. 4
Remove the control
component knobs.
Fig. 5
1 - FIXING SCREWS
FOR COMPONENT.
2 - CONTROL PIN
FOR COMPONENT.
SOI 02.10 FV 7/142 599 70 59-01