Normal Electromechanical Version With Hob Controls - Electrolux Built-in ovens Service Manual

2.6.2.5 - NORMAL ELECTROMECHANICAL VERSION WITH HOB CONTROLS

In the version with hob controls, after unscrewing the screws of the upper panel, to remove a
control component: oven thermostat, function selector, hob energy regulators, indicator lights, etc.
1 - Remove the control panel front panel (see chapter 2.4 entitled REMOVING THE CONTROL
PANEL depending on the styling).
2 - Detach the connection wires of the component, marking their position
3 - Remove the fixing screws of the component (see chapter 2.4 entitled REMOVING THE
CONTROL PANEL depending on the styling).
4 - Remove the component.
Fig. 90
1 - ENERGY REGULATORS FOR THE HOB
2 - ELECTRONIC PROGRAMMER
3 - INDICATOR LIGHTS
4 - FUNCTION SELECTOR
5 - OVEN THERMOSTAT
6 - CONNECTION CONNECTOR FOR THE HOB
N.B.: From January 2010 (serial number 001....) access to the top of the oven
has improved thanks to the progressive introduction of a new one-piece top oven
cover (see chapter 2.6.1).
SOI 02.10 FV 46/142 599 70 59-01