3.4.3
Restart Command
Syntax:
restart
The
command instructs the system to perform a warm start, i.e., restarting the system without turning
restart
the power on and off.
It is very important that you remember your password. If you forget it, refer to the Troubleshooting section
3.4.4
Passwd Command
Syntax:
passwd
The
command changes the management password. The management password is used for authentication
passwd
at console or telnet login. This command is only allowed for local console management sessions. The management
password must be from 1 to 8 characters long and any character is accepted. The factory default password is
"1234".
3.4.5
Config Print Command
Syntax:
config print
The
command lists all current system configuration settings.
config print
3.4.6
Config Save Command
Syntax:
config save
The
command saves all system configurations into nonvolatile memory. You must use this
config save
command to save any configurations that you make, otherwise the AES-100 will return to its default settings when
it is restarted.
3.4.7
Exit Command
Syntax:
exit
The
command terminates the console or telnet mana gement session.
exit
Software Configuration
for help.
AES-100 User's Guide
3-3