Handle Assembly - Kenmore 111.784 Owner's Manual

HANDLE ASSEMBLY
ORemove clean solution tank (A) from carpet
cleaner. Remove hose end (B) from hose holder (C).
ORemove bolts and nuts packet taped to
upper handle. With hose hook and cord hook
to back of carpet cleaner, push upper handle (D)
down onto lower handle (E). Push bolts into holes
on front of handle. If bolts will not go through
hole easily, handle is not pushed completely
down.
OPlace nuts (F) in recessed areas on back of
lower handle. Hold each nut in place while
tightening each bolt (G) securely from the front of
the handle with a Phillips screwdriver.
OReplace clean solution tank by positioning bot=
tom first. Press on top of tank to secure latch in
place.
STORING HOSE AND TOOL
OSlide tool mode lever (H) to the left. Wrap
hose around upper hose hook (I) on upper
handle. Press hose into clip (J). Continue wrapping
hose down, press into clip (K) and place behind
bottom hose holder (L). Pull hose up and press into
clip (J). Wrap around upper hose hook (I), bypass-
ing clip (K) and push hose end fully into holder (M).
OPress cord into cord clip (N) on back of han-
dle. Pull cord tight and wrap cord around cord
hooks (O).
10