Handle Assembly - Kenmore 473.85930 Owner's Manual

HANDLE ASSEMBLY
ORemove clean solution tank (A) from carpet
cleaner. Remove hose end (B) from hose holder (C).
ORemove bolts and nuts packet taped to
upper handle. With hose hook and cord hook
to back of carpet cleaner, push upper handle (D)
down onto lower handle (E). Push bolts into holes
on front of handle. If bolts will not go through
hole easily, handle is not pushed completely
down.
, i
o
i
i
OPlace nuts (F) in recessed areas on back of
lower handle. Hold each nut in place while tight-
ening each bolt (G) securely from the front of the
handle with a Phillips screwdriver.
_tReplace clean solution tank by positioning bot=
om first. Press on top of tank to secure latch in
place.
STORmNG HOSE AND TOOLS
OWrap hose around hook (H) on upper handle.
Press hose into clips (I). Slide tool mode lever
(J) to the left and push hose end fully into
holder (K).
OPress cord into cord clip (L) on back of handle.
Pull cord tight and wrap cord around cord
hooks (M).
i
10