Select Tool; After Using Tool - Kenmore 111.784 Owner's Manual

_To move your carpet cleaner from room to
room, put handle in upright and locked position
and tilt carpet cleaner back on its wheels and push
forward.
BRUSH ON/OFF
Your carpet cleaner has two agitator brush settings.
ON =for normal cleaning of carpets
OFF =for cleaning carpets when brushing is not
desired. (Such as when picking up liquid spills.)
_Slide selector button (A) to the desired setting
before turning unit on and cleaning=
SELECT TOOL
_Staidupholstety nozzle has a built:in brush to
help provide the scrubbing action some spots
may need for removal.
HOW TO ATTACH TOOL
Disconnect carpet cleaner from electrical outlet.
Place handle in upright position and remove hose
from rack.
_Slide tool mode lever (A) to the right.
The handle must be in the upright position in
order for cleaning solution to get through the
hose.
_Connect tool to hose by sliding it onto connec-
tor until the tab (B) locks it securely.
Using your thumb, push forward and up on the
lever (C) to remove tool as shown.
AFTER USING TOOL
When finished using the hose and tool, remove
water from the hose.
Turn carpet cleaner on and hold end of hose up for
several seconds. Do not press trigger.
Remove solution (top) tank. Squeeze and hold trig=
get over sink or drain to remove remaining solution
from hose while the carpet cleaner is still on.
\
J
C