Set Up Instructions; Storage; Maintenance - Stamina INSTRIDE PLUS Owner's Manual

SET UP INSTRUCTIONS

Place the INSTRIDE PLUS in the area where it will be used. It is recommended that the INSTRIDE PLUS
be placed on an equipment mat. The max. operation dimensions of INSTRIDE PLUS is approximately
17 3/8" long x 11 3/4" tall x 12 3/8" wide. (These dimensions may vary up to one inch.) An area 6 feet wide
x 6 feet long is required for safe operation of the INSTRIDE PLUS. Make sure that adequate space is
available for access to and passage around the INSTRIDE PLUS.
LEVELING: Adjust the location of INSTRIDE PLUS on the floor to make the stepper sets on the floor
without rocking.
MOVING:
Grasp the Front and Rear Stabilizers to move the INSTRIDE PLUS. Do not use the Pedal
Arms to move the INSTRIDE PLUS. The Pedal Arms will move and the Shock may pinch your
hand or fingers.
FUNCTION INSPECTION
NOTE: Always make sure that the CABLE(9) is
properly seated in the groove on the PULLEY(8) before
using the INSTRIDE PLUS.
Visually inspect the INSTRIDE PLUS to verify that
assembly is as shown in the above illustrations. Check
the function of the INSTRIDE PLUS. Stand on the
foot pedals and slowly move your highest foot
downward and follow the natural path of the machine.
The Shocks should provides resistance for your
workout.
Inspect the RESISTANCE CORDS(32) for nicks and
cuts. Replace damaged RESISTANCE CORDS(32).

STORAGE

1. To store the INSTRIDE PLUS simply keep it in a clean dry place.
2. The min. rest dimesions of INSTRIDE PLUS is approximately 17 3/8" long x 8 1/4" tall x 12 3/8" wide.
These dimensions will vary. Please measure your INSTRIDE PLUS if exact dimensions are needed.
3. Grasp the Front and Rear Stabilizer to move the INSTRIDE PLUS. Do not use the Pedal Arms to move
the INSTRIDE PLUS.
4. To avoid damage to the electronics, remove the battery before storing the INSTRIDE PLUS for one year
or more.

MAINTENANCE

The safety and integrity designed into the INSTRIDE PLUS can only be maintained when the INSTRIDE
PLUS is regularly examined for damage and wear. Special attention should be given to the following:
1. Inspect the RESISTANCE CORDS(32) for nicks and cuts. Replace damaged RESISTANCE CORDS(32).
2. Verify that the Shocks provides resistance. The Shocks should provide many years of use.
3. Shocks on steppers get HOT during use. To avoid burns, do not touch the shocks until they have time to
cool.
4. Verify that the Warning Label is in place and easy to read. Call Stamina Products immediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
5. It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
6. Worn or damaged components shall be replaced immediately or the INSTRIDE PLUS removed from
service until repair is made.
7. Only Stamina Products supplied components shall be used to maintain/repair the INSTRIDE PLUS.
8. Keep your INSTRIDE PLUS clean by wiping with an absorbent cloth after use.
6