Set Up Instructions - Stamina 40-0041A Owner's Manual

SET UP INSTRUCTIONS

Place the Stamina® Mini Stepper in the area where it will be used. It is recommended that the
Stamina® Mini Stepper be placed on an equipment mat. The maximum operation dimensions of the
Stamina® Mini Stepper is approximately 15.3 inches long x 12 inches wide x 12 inches tall. (These
dimensions may vary up to one inch.) Make sure that adequate space is available for access to
passage around and emergency dismount from the Stamina® Mini Stepper. A minimum of 20 inches
on both sides and 20 inches either behind or in front of the Stamina® Mini Stepper is required for safe
operation.
LEVELING: Adjust the location of Stamina® Mini Stepper so the stepper sits on the floor without
rocking.
MOVING: The Stamina® Mini Stepper must be lifted to be moved. Grasp the Front and Rear
Stabilizers to move the Stamina® Mini Stepper. Do not use the PEDAL ARMS(10, 14)
to move the Stamina® Mini Stepper. The PEDAL ARMS(10, 14) will move and the
SHOCK(26) may pinch your hand or fingers.
FUNCTION INSPECTION:
NOTE: Always make sure that the CABLE(4) is properly seated in the groove on the PULLEY(5) before
using the Stamina® Mini Stepper.
Visually inspect the Stamina® Mini Stepper to verify that assembly is as shown in the above illustration.
Check the function of the Stamina® Mini Stepper. Stand on the foot pedals and slowly move your
highest foot downward and follow the natural path of the machine. The SHOCKS(26) should provide
resistance for your workout.
CAUTION: Locate and read the CAUTION LABEL(28) on the Stamina® Mini Stepper. Make sure that
all users read the CAUTION LABEL(28) before using the product.
Rear Stabilizer
8
Front Stabilizer
Equipment Mat
(not included)