Replacing The Lcd Assembly Lid - Packard Bell EasyNote NM85 Service Manual

Replacing the LCD assembly lid

92
CHAPTER 3: Replacing notebook components
Tools you need to complete this task:
Phillips #0 screwdriver
Flat screwdriver
Screws removed during this task:
•
1 black M2×3 (hard drive)
•
1 black M2.5×6 (optical drive)
•
2 M2.5×6 black (palm rest - top side)
•
in step 13 of the
•
Indicated by B in
page 49
•
2 black M2.5×4 (LCD front panel)
•
To replace the LCD assembly lid:
1
Complete the steps in
2
Remove the LCD panel assembly by performing steps
"Replacing the LCD panel assembly"
3
Remove the LCD front panel by performing steps
LCD front panel"
4
Remove the LCD panel by performing steps
panel" procedure on
5
If you are going to use the same webcam, microphone and wireless
antennas, remove these items from the old LCD assembly lid and attach
them to the new one. Refer to the related replacement procedure on previous
pages for instructions.
6
Place the LCD panel with hinge brackets back on the LCD assembly lid.
7
Return the panel bracket screws to their places.
8
Reinstall the LCD front panel by performing steps
LCD front panel"
Make sure the webcam lens is aligned with camera peephole on the LCD
front panel before you secure the panel in place.
9
Reinstall the LCD panel assembly by following the steps
"Replacing the LCD panel assembly"
10
Reinstall the palm rest by performing steps
rest" procedure on
or Non-marring plastic scribe
6 M2×3 black (palm rest - base side) - Indicated by A
"Replacing the palm rest"
9 black M2.5×6 (palm rest - base side) -
step 13 of the "Replacing the palm rest"
6 chrome M2.5×4 (LCD panel)
"Preparing the notebook" on page
procedure on page 79.
page 83.
procedure on page 79.
page 49.
procedure on page 49
37.
2–15
procedure on page 61.
3–5 of the
4–6 of the "Replacing the LCD
6–9 of the
16–26
procedure on page 61.
17–19 of the "Replacing the palm
procedure on
of the
"Replacing the
"Replacing the
of the