Table of Contents
Advertisement
Replacing the system board
Tools you need to complete this task:
Screws removed during this task:
www.packardbell.com
Phillips #0 screwdriver
Flat screwdriver
•
1 black M2×3 (hard drive)
•
1 black M2.5×6 (optical drive)
•
2 M2.5×6 black (palm rest - top side)
•
in
step 13
of the
•
Indicated by B in
page 49
•
1 black M2×3 (system board)
To replace the system board:
1
Complete the steps in
2
Complete the steps in
3
Remove the memory from the old system board and install it on the new
system board by following the instructions in the
memory modules"
4
If the notebook has a wireless card installed, remove the card from the old
system board and install it on the new system board by following the
instructions in the
5
Remove the hard drive by performing steps
hard drive"
procedure on
6
Remove the optical drive by performing steps
optical drive"
procedure on
7
Remove the keyboard by performing steps
keyboard"
procedure on
Caution
The keyboard is connected to the notebook through a keyboard
cable. Disconnect this cable first before pulling the keyboard away
from the palm rest assembly.
8
Remove the palm rest by performing steps
rest"
procedure on
9
RRemove the hard drive by performing steps
hard drive"
procedure on
or
Non-marring plastic scribe
6 M2×3 black (palm rest - base side) - Indicated by A
"Replacing the palm rest"
9 black M2.5×6 (palm rest - base side) -
step 13
of the
"Replacing the palm rest"
"Preparing the notebook" on page
"Removing the battery" on page
section on
page
42.
"Replacing the wireless card"
page
40.
page
45.
page
47.
page
49.
page
40.
procedure on
page 49
procedure on
37.
38.
"Adding or replacing
section on
page
3
and
4
of the
"Replacing the
3
and
4
of the
"Replacing the
3–5
of the
"Replacing the
7–16
of the
"Replacing the palm
3
and
4
of the
"Replacing the
43.
69
- Quick Links:
- Memory
- Hard Disk Drive
Hide quick links:
Advertisement
Table of Contents
