Replacing the Bluetooth module
Tools you need to complete this task:
Screws removed during this task:
www.packardbell.com
Phillips #0 screwdriver
Flat screwdriver
•
1 black M2×3 (hard drive)
•
1 black M2.5×6 (optical drive)
•
2 M2.5×6 black (palm rest - top side)
•
in
step 13
of the
•
Indicated by B in
page 49
To replace the Bluetooth module:
1
Complete the steps in
2
Complete the steps in
3
Complete the steps in
4
If the notebook has a wireless card installed, unplug the antenna cables.
5
Remove the hard drive by performing steps
hard drive"
procedure on
6
Remove the optical drive by performing steps
optical drive"
procedure on
7
Remove the keyboard by performing steps
keyboard"
procedure on
Caution
The keyboard is connected to the notebook through a keyboard
cable. Disconnect this cable first before pulling the keyboard away
from the palm rest assembly.
8
Remove the palm rest by performing steps
rest"
procedure on
9
Remove the USB board by c.
or
Non-marring plastic scribe
6 M2×3 black (palm rest - base side) - Indicated by A
"Replacing the palm rest"
9 black M2.5×6 (palm rest - base side) -
step 13
of the
"Replacing the palm rest"
"Preparing the notebook" on page
"Removing the battery" on page
"Removing the bay cover" on page
page
40.
page
45.
page
47.
page
49.
procedure on
page 49
procedure on
37.
38.
39.
3
and
4
of the
"Replacing the
3
and
4
of the
"Replacing the
3–5
of the
"Replacing the
7–16
of the
"Replacing the palm
67